Open Access Journal

Manuscript submission

Volume 66 (2015), issue 1
Title:

Impact of Wood Species, Dimensions and Drying Temperature on Sorption Behaviour of Wood

Research subject and fields:
Abstract:

This research paper examines the interdependence between wood sorption properties and its dimensions, species and drying temperature. The research was carried out on specimens of six species of wood (oak, ash, aspen, birch, spruce and pine) which had different dimensions and were dried at temperatures ranging between 30 and 90 °C. Subsequently specimens underwent the moistening and air drying process, and the following parameters were recorded: moistening and drying rate, moisture content distribution, steady moisture content and sorption hysteresis. It was established that sorption hysteresis was most affected by the cross section dimensions of the specimen. It was determined that, when the thickness of wood specimens increases from 7 to 30 mm, sorption hysteresis grows up to 8 times. The steady moisture content depends on the density, measurements and drying temperature of the specimen.

Publisher

Faculty of Forestry and Wood Technology
HRCAK
ORCID
DOI
CROSSREF

DRVNA INDUSTRIJA Scientific Journal of Wood Technology

ISSN 0012-6772 (Print) / ISSN 1847-1153 (Online)

Faculty of Forestry and Wood Technology University of Zagreb, Svetošimunska 25, 10000 Zagreb, Hrvatska - Croatia
Tel: +3851 2352 430, E-mail: drind@sumfak.hr
Editor-in-Chief: Prof. Ružica Beljo-Lučić, Ph.D. E-mail: editordi@sumfak.hr
Cookie settings